Normally, the entry delay is set to 45 seconds. The effectiveness of the alarm is dependent on this time being as short as possible. This time can be changed depending on your preference.
“AC” loss is an indicator that your system is not receiving electrical power. If you are not currently experiencing a power outage, check all of your circuit breakers. A service visit may be required.
Do you have an internet connection at your home? Are cameras plugged in? Try rebooting the cameras and your ReadyHome router to reconnect the cameras. Try rebooting the camera using these steps: Unplug and replug the camera from the wall. … Continued
Yes, it is recommended and some jurisdictions (city, county, etc.) even require you to register your alarm system. If you have not registered your alarm system, please click here to access your form. You will then need to submit your … Continued
No, not necessarily. The detectors can normally be painted around. However, DO NOT PAINT THE DETECTORS. If you need to take them down, please call us to schedule a site visit.
This will vary based on your systems communication format. Typically the signal is received in less than a minute.
“FC” will appear on the keypad any time the alarm system tried to report an event to the central station and the message was not received by the central station. The most common reasons this can occur are that your … Continued
Try a hard reboot using these steps: Remove the stand Remove the battery compartment Take the battery out and unplug power for a few seconds Reconnect everything If this does not work, please call us.
Wireless Security System Click Here Wired Security System Click Here
Once the length of the contract has been fulfilled, you own the equipment.